Product ID:FP-30 PENETRANT
MSDS Date:01/01/1987
FSC:6850
NIIN:00-782-2740
Kit Part:Y
MSDS Number: BFPNT

Emergency Phone: 213-861-6324

Info Phone: 213-861-6324

Cage: 21045

Telephone: 562-861-6324/FAX 923-8370

Cage: 21405

MANUFACTURER STATED THIS AEROSOL PRODUCT DID NOT CONTAIN

RTECS: 9999999ZZ

HYDROCARBON PROPELLANTS

ACGIH TLV: 5 MG/CUM(MIST)

Effects of Overexposure:IRRIT TO RESP TRACT, CENTRAL NERVOUS SYSTEM.
STIMULATION FOLLOWED BY DEPRESSION.

First Aid:FLUSH EYES W/PLENTY OF WATER FOR 15 MINUTES. GET MED ATTN.
WASH SKIN W/SOAP & WATER. APPLY SKIN CREAM. RMV CONTAMINATED
CLOTHING & LAUNDER BEFORE REUSE. INHAL: RMV TO FRESH AIR. GIVE CPR
IF NOT BREATH ING OR OXYGEN IF BREATHING IS DIFFICULT.

Flash Point:N/R(AEROSL
Extinguishing Media:CO*2, FOAM, DRY CHEMICAL
Fire Fighting Procedures:COOL CANS W/WATER SPRAY. WEAR SCBA&PROTECT
EQUIPMENT
Unusual Fire/Explosion Hazard:SPRAY CAN PKG PROPELLANT IS HYDROBARBON &
FLAMMABLE. TEMP ABOVE 120F MAY CAUSE CAN TO BURST.

Spill Release Procedures:ELIMINATE ALL IGNITION SOURCES, PICK UP
W/ABSORBENT SWEEPING COMPOUND OR APPLY "EMULSIFIER" AND FLUSH TO
CHEM SEWER W/LG VOLUMN OF WATER.

Handling and Storage Precautions:STORE AWAY FROM HEAT. AVOID INHALATION
OF HIGH CONCENTRATIONS OF VAPORS/MISTS. AVOID SKIN OR EYE CONTACT.
Other Precautions:WASH THOROUGHLY AFTER USE AND BEFORE EATING OR
SMOKING.

Respiratory Protection:NONE NORMALLY REQD. NIOSH APPROVED MIST RESP IF
REQD.
Ventilation:MECHANICAL REQD. LOCAL RECOMMENDED.
Protective Gloves:RUBBER/NEOPRENE
Eye Protection:SAFETY/CHEM GOGGLES
Other Protective Equipment:NEOPRENE/RUBBER APRON.
Supplemental Safety and Health
MSDS NOT DATED. ITEM IS PART OF A THREE PART KIT. P/NS: DR-60 REMOVER &
D-100 DEVELOPER, THIS NSN, ARE ALSO PART OF KIT. I/A/W MIL-I-25135C
GR VII. REPLACED BY P/N RC-65 PENETRANT I/A/W REV D.

HCC:V2
Boiling Pt:B.P. Text:N/R (AERO)
Spec Gravity:0.95
Evaporation Rate & Reference:0.1 (BU AC=1)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:YELLOW GREEN LIQUID, PETROLEUM ODOR.
Percent Volatiles by Volume:NIL

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS
Stability Condition to Avoid:NONE SPECIFIED BY MFG. AVOID HIGH TEMP.
Hazardous Decomposition Products:TOXIC FUMES,CO,CO*2, SOT

Waste Disposal Methods:DO NOT INCINERATE OR PUNCTURE PRESSURIZED
AEROSOL CANS. COLLECT & TURN IN TO LICENCED WASTE DISPOSAL
FACILITY. DISPOSE I/A/W ALL LOCAL,STATE & FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.